SmartStart™

The SmartStart™ LTE Cat 1 and Cat 4 family of routers and gateways are the perfect way to connect Ethernet, Wi-Fi, and serial devices to an LTE network.

  • Certified by Verizon and AT&T; supported by most major carriers
  • Powerful processor enough to handle the full range of LTE communication
  • 1x Ethernet 100 Mbps – RJ45, 10/100 Mbps, 1.5kV RMS
  • 1x RS232 port – DB9 Female
  • Two SIM card holders on the rear side of the router (given DIN holder on back side) – 2 Mini SIMs (2FF)
  • 1x I/O – Integrated in 4 way Molex mini connector – Configurable I/O pin on power connector
  • 1x Digital Input : 0 to 36 VDC, logic 0: 0 to 0,7 V, logic 1: 1,6 V to 36 V
  • 1x Digital Open Collector Output > sinking 200 mA/ 36 V DC
  • Input voltage range is from 9 Vdc to 36 Vdc (4-Way Molex moni-fit connector)
  • Power consumption with WiFi – Average / Peak / Sleep Mode – 2,7 / 5.5 W / 40 mW
  • Power consumption without WiFi – Idle / Average / Peak / Sleep Mode – 2,1 / 4.8 W / 40 mW
  • Current with WiFi / without WiFi – 0.65 A Max / 0.55 A Max
  • Temperature range with WiFi – Operating / Storage – -25 to +55 °C / -40 to +85 °C
  • Temperature range without WiFi – Operating / Storage – -40 to +75 °C / -40 to +85 °C
  • Humidity – Operating / Storage (non condensing) – 0 to 95 % / 0 to 95 %
  • Cold Start – -40 °C
  • Operating Altitude – 2000 m / 70 kPa
  • Enclosure Rating – IP30
  • LED Indicators – PWR, DAT, WAN, ETH
  • 2x ANT connectors, WiFi antenna – *optional – R-SMA connector
  • Enclosure Dimensions – 87x30x127mm (150mm including wall month sides)
  • Weight – 187g
  • Wi-Fi 802.11 b/g/n – *optional (AP/STA) 55+ clients supported (-25 to +55 °C)
  • Support of IPv6, Easy firmware update