The PB-DAC3 is a 4 channel 12-bit opto-isolated D/A piggyback for use with ModPack carrier boards. All outputs are independent and galvanically isolated from the system supply. Bipolar or unipolar conversion is indicated by the version being ordered. Board specific calibration data remain stored in an on-board EEPROM for software gain/offset correction. The PB-DAC3 has software support for both OS9 and VxWorks.
The PB-DOUT2 is a 16 channel digital output module based around an intelligent “SMART” transistor which prevents the circuitry being damaged through overload or over-heating. High-side switches (common Vcc) are used to power ground referenced loads and provide protection against short circuits and overloading. The PB-DOUT2 has
software support for both OS9
and VxWorks.
The VM6054 6U VME 2eSST Single Board Computer is built around Intel®’s state-of-the-art 3rd Generation Core™ i7 quad-core processor.
The VM6054 provides exceptional I/O capabilities onboard and outstanding flexibility by providing support for PMC and XMC including flexible I/O, storage mezzanines, and personality modules.
Accessory cards such as VME 6U dual PMC carrier and rear transition module complete the ecosystem.
Users of PENTXM2, PENTXM4 and VM6050 will find the same front and rear interfaces, making VM6054 the perfect replacement, and investment preservation with Kontron products an actual experience already spanning a decade.
The VM6050 is built around Intel®’s state of-the-art Core™
i7 dual-core processor. The VM6050 provides exceptional I/O
capabilities onboard and outstanding flexibility by providing
support for both PMC, XMC and FMC mezzanine cards.
The VM6050’s VME interface helps customers preserve their
investment in legacy VME equipment.
A 12 channel industrial I/O piggyback for use with dedicated carrier boards for high-voltage operation.
Each of the 12 inputs are independent of each other requiring neither common GND nor common Vcc connections and possess 2500V DC isolation between the input and system
ground and 100V DC between individual inputs.
An 8 channel 12-bit opto-isolated A/D piggyback for use with ModPack carrier boards. All inputs are differential and galvanically isolated. Bipolar or unipolar conversion as well as the choice between voltage or current conversion is indicated by the version being ordered. Board specific calibration data remain stored in an on-board EEPROM for software gain/offset correction. The PB-ADC3 is supported under both OS9 and
VxWorks.
