ADAM-5240

4-axis Stepping/Pulse-type Servo Motor Control Module

  • High-speed 4-axis stepping/pulse-type servo motion control
  • Hand wheel and jog function
  • 2/3-axis linear interpolation function
  • 2-axis circular interpolation function
  • Continuous interpolation function
  • Programmable T/S-curve acceleration/deceleration rate
  • Up to 4 MPPS output for each axis
  • Two pulse output types: CW/CCW or Pulse/Direction
  • Up to 1 MHz encoder input for each axis
  • Two encoder pulse input types: A/B phase or Up/Down
  • Position management and software limit switch function
DATASHEET
PIDE PRESUPUESTO

Advantech’s Industrial Automation Group introduces the ADAM-5240, a 4-axis Stepping/Pulse-type Servo Motor Control Module for use with ADAM-5550 Series PACs (Programmable Automation Controllers). ADAM-5240 is is fully integrated to fulfill general purpose motion applications. Equipped with high speed 4-axis motion control module that simplifies stepping and pulse-type servo motor control, ADAM-5240 provides advanced performance.

Related Products

ADAM-5202

ADAM-5202

ADAM-5202 is a 2-ring AMONet module that provides 128 maximum slaves and supports 100-meter long distance communications. The transmission speed can support 2.5, 5, 10 or 20 Mbps with automatic data flow control. It accepts half duplex RS-485 serial interfaces with transformer isolation. This module can also function as a motion module for AMONet Master Control.

Categoría: .
ADAM-5030

ADAM-5030

ADAM-5030 is a 2-slot secure digital card storage module that provides 2 USB ports and 2 SD slots. It is fully compliant with USB 2.0 and FAT16 and is also low power consuming, at only 0.5W. According the volume of SD Card, you can extend the memory of your controller up 2 GB. Unlike commercial modules, it is very rugged, and has a very long lifecycle.

Categoría: .