- 6U Dual 64/100 PMC VME carrier
- PCI-Express x4 interface onto 5GHz P0 connector
- 3.3V PCI signaling, 5V tolerant for PMC-1
- Commercial Air-Cooled and Rugged Conduction-Cooled versions
- PMC rear I/O routed to P2
V2PMC2
The V2PMC2 PCI-X/PMC carrier card is a 6U VME that holds up to two single-width or one double-width PCI-X/PMC modules.
The V2PMC2 works in association with a PCI-Express host which is connected to it through a x4 PCI-Express serial link onto P0 connector.
Related Products
VM6052
The VM6052 6U VME 2eSST Single Board Computer is built around Intel®’s state-of-the-art 3rd Generation Core™ i7 dual-core processor.
The VM6052 provides exceptional I/O capabilities onboard and outstanding flexibility by providing support for PMC and XMC including flexible I/O, storage mezzanines, and personality modules.
Accessory cards such as VME 6U dual PMC carrier and rear transition module complete the ecosystem.
Users of PENTXM2, PENTXM4 and VM6050 will find the same front and rear interfaces, making VM6052 the perfect replacement, and investment preservation with Kontron products an actual experience already spanning a decade.
VM6054
The VM6054 6U VME 2eSST Single Board Computer is built around Intel®’s state-of-the-art 3rd Generation Core™ i7 quad-core processor.
The VM6054 provides exceptional I/O capabilities onboard and outstanding flexibility by providing support for PMC and XMC including flexible I/O, storage mezzanines, and personality modules.
Accessory cards such as VME 6U dual PMC carrier and rear transition module complete the ecosystem.
Users of PENTXM2, PENTXM4 and VM6050 will find the same front and rear interfaces, making VM6054 the perfect replacement, and investment preservation with Kontron products an actual experience already spanning a decade.
VM6050
The VM6050 is built around Intel®’s state of-the-art Core™
i7 dual-core processor. The VM6050 provides exceptional I/O
capabilities onboard and outstanding flexibility by providing
support for both PMC, XMC and FMC mezzanine cards.
The VM6050’s VME interface helps customers preserve their
investment in legacy VME equipment.
PB-DOUT2
The PB-DOUT2 is a 16 channel digital output module based around an intelligent “SMART” transistor which prevents the circuitry being damaged through overload or over-heating. High-side switches (common Vcc) are used to power ground referenced loads and provide protection against short circuits and overloading. The PB-DOUT2 has
software support for both OS9
and VxWorks.
PB-DAC3
The PB-DAC3 is a 4 channel 12-bit opto-isolated D/A piggyback for use with ModPack carrier boards. All outputs are independent and galvanically isolated from the system supply. Bipolar or unipolar conversion is indicated by the version being ordered. Board specific calibration data remain stored in an on-board EEPROM for software gain/offset correction. The PB-DAC3 has software support for both OS9 and VxWorks.